Request a Quote

By contacting us your information will only be used to respond to your enquiry, we will comply with the Privacy Protection Agreement to protect your privacy.
Thank you for your trust.

Power Supply Connection And Ground Connection Of Eaglestar Mobile Fuel Dispenser

Mac 4 2021-12-03 15:30:51

Power supply is required for an Eaglestar mobile fuel dispenser, just like our other products, such as EG1 (, EG3 (, EG5 (, EG6 ( and EG7 (


When performing the power supply connection and ground connection for the mobile fuel dispenser, you need to see the following:


The 380V three-phase four-wire system standard is used for the power line of the mobile fuel dispenser, so it is recommended to use the 3*2.5+1*1.5 cable. Make the cable go through the power reserve pipe on the right side of the device, and connect it to the wiring in the explosion-proof electric cabinet. The connection point of the grounding wire lies at the base of the unloading pump. It is recommended to use the multistrand single-core copper wire of no less than 4 square meters.